ESA Smart Meter (40+ Electrical Parameters)
Acquires electrical parameters and energy on pumps, fans and related circuits
Pump and fan energy efficiency monitoring should first define equipment boundaries, operating conditions, operating modes and metering objects. ESA acquires electrical parameters, ESE analyzes harmonics where required, EST monitors confirmed electrical node temperatures, CW aggregates data and can connect PLC, flow or pressure interfaces, and FEXLINK builds baselines and anomaly records. Without nameplate, operating condition and load data, no efficiency conclusion is drawn.
The solution suits energy and operating analysis for pumps, fans and similar rotating equipment. It focuses on the equipment register, operating-condition data and baselines, and does not commit to a fixed energy saving rate.
Acquires electrical parameters and energy on pumps, fans and related circuits
Analyzes harmonics and other power quality indices where required; specific model capabilities must be confirmed
Monitors confirmed electrical nodes or auxiliary temperatures; measurement points are confirmed by model
Aggregates electrical and third-party process data and performs buffering and interface conversion
Builds equipment baselines, trends, alarms and maintenance views
Candidate where additional DI/DO or analog signals are needed; capacity and isolation are confirmed by model
Candidate gateway for on-site aggregation and edge processing
Used for analytical studies where complete baselines and labels exist; model capability is accepted per project
ESA, ESE and EST acquire electrical data; third-party instruments or PLCs provide flow, pressure, valve position or operating status.
CW or ESX aggregates the data and processes it according to project rules.
FEXLINK builds the equipment operating-condition and efficiency baseline.
Equipment and energy staff review anomalies, maintenance events and operating changes.
ESA, ESE and EST acquire electrical data;third-party instruments or PLCs provide flow, p…
ESA Smart Meter (40+ Electrical Parameters) · ESE Power Quality Monitor (Harmonics & THD)
Equipment nameplate, circuit and measurement point correspond one-to-one
The solution does not directly produce hydraulic or aerodynamic efficiency conclusions for pumps or fans
Power, operating status and load trends can be analyzed, but complete efficiency indices usually require flow, pressure or equipment operating data.
The VFD protocol, point list and authorization must be confirmed and connected through a gateway or project interface. Not every model should be assumed to be open.
Rules can be set from operating status and power consumption, but thresholds must be validated against equipment type and operating conditions.
Use the same equipment boundary, operating conditions and statistical period, and exclude output and environmental changes.
Studies are possible when data is complete and labels are clear. Model output requires project acceptance and manual review.
Share the application, circuit conditions and existing system interfaces so engineers can confirm selection and implementation boundaries.
Contact FEXLINK