ESP Neutral-Ground Voltage Monitor
Monitors N-PE neutral-to-earth voltage and available switch status; wiring method and range are confirmed by model
Neutral-to-earth voltage monitoring must be built on a defined system grounding arrangement and N-PE wiring conditions. ESP monitors the neutral-to-earth voltage, SFA acquires electrical parameters on confirmed circuits, ESX aggregates the data and FEXLINK builds trends and alarms. TN, TT and IT systems differ in monitoring points, reference earth and permissible range, so a single threshold cannot be given before the distribution structure is verified.
The solution targets data centers, precision equipment rooms and sensitive loads. It focuses on correlating neutral-to-earth voltage with load, switch status and time, and avoids confusing grounding resistance, residual current and neutral-to-earth voltage.
Monitors N-PE neutral-to-earth voltage and available switch status; wiring method and range are confirmed by model
Acquires voltage, current, power and energy on associated circuits; specific capabilities are confirmed by model
Aggregates neutral-to-earth voltage, electrical parameter and status data and performs edge buffering and upload
Builds trends, events, alarms and response records
ESP connects to confirmed N-PE monitoring points and SFA connects to the associated precision load circuits.
ESX aggregates data and unifies time, without changing the original distribution wiring.
FEXLINK builds room, switchgear and circuit views.
O&M staff review neutral-to-earth voltage, load changes and alarms together.
ESP connects to confirmed N-PE monitoring points and SFA connects to the associated prec…
ESP Neutral-Ground Voltage Monitor · SFA Multi-Parameter Electrical Controller
N-PE measurement points, reference earth and circuits have an explicit correspondence
Neutral-to-earth voltage monitoring cannot replace grounding resistance measurement or insulation monitoring
It cannot be judged in isolation from the grounding arrangement, equipment requirements and measurement conditions. Set project thresholds after defining the reference earth and operating conditions.
No. ESP monitors N-PE neutral-to-earth voltage; grounding resistance requires products such as FR or FRP.
Neutral-to-earth voltage is affected by load and distribution operations. Joint records help identify the source of the change.
They should not be shared directly. Grounding arrangements and fault characteristics differ, so thresholds must be set by project design.
Yes, through an interface confirmed by the project, after agreeing points, alarm grading and data responsibility.
Share the application, circuit conditions and existing system interfaces so engineers can confirm selection and implementation boundaries.
Contact FEXLINK